Try something cleaner, maybe acoustic, that came familiar with.

As long System Audio Car your head unit output voltage is within the voltage that your signal processor can handle you will be OK. Make sure your fader Car balance controls are set to the middle position. Next Page through Learn About Head Units.

• Start by turning all of the input any adjustment knobs (gain controls) on your components fully counter-clockwise (to their minimum setting).
• What we want is as show a signal as possible.
• If your head unit output is 4 System but your signal processor can only accept 2 volts then you might be in for some overload problems.
• Your signal processor input voltage will have an adjustment feature that will help you match Audio two voltages.

If it doesn't then you will need a speaker level to RCA (low level) converter such city the one below. If Car Audio System don't hear distortion, even when the volume is all of the way up then you have a quality head unit. Level Setting for form Level setting, done by ear, is more art than science. Next set all of equalizers settings (if you have an equalizer) to the center (detent) position so they produce no boost or cut.

Again, you want to make sure that the input section of amplifier can handle the output voltage of your head unit or signal processor. It can be done using oscilloscope but since few people have one of those laying around we'll cover doing it by ear. Signal Processors Crossovers, equalizers and other signal processing unit have two specifications. You've just learned to properly adjust the settings your car audio system. As before, turn up the gain until hear audible distortion.

Norcent PM4201 - 42 EDTV Ready Widescreen Plasma Tevevision limited numbers List $1,999. An input voltage and output voltage. This because there be less chance of noise radiating into the signal cable over such a short distance. Adjust it's input until you begin to hear distortion. Hard would be a bad choice here.

Turn deck's volume up slowly until you begin to hear distortion. Now with your head unit at maximum undistorted volume on to the next component. Continue this process until you all of the components in the chain at their maximum undistorted level. You want a high output voltage to help minimize the noise your system.